Removing The Gearcase - Whirlpool Maytag MVW6200KW Manuel Technique

6. Complete the steps 1-7 from section Removing the Shifter to remove
the shifter.
7. Unsnap the tabs that secure the splutch housing and lift off.

Removing the Gearcase

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
washer.
Failure to do so can result in back or other injury.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Complete the steps 1-2 from section Removing the Impeller.
4. Complete the steps 1-2 from section Removing the Basket.
5. Use cardboard or padding to lay washer on the front cabinet.
6. Complete the steps 1-6 from section Removing the Drive Belt and
Motor.
7. Complete the steps from 1-7
8. Complete the steps 1-7 from section Removing the Shifter.
DO NOT REMOVE OR DESTROY
FOR SERVICE TECHNICIAN'S USE ONLY
Removing the Splutch.
9. Remove the capacitor by disconnecting harness and removing
mounting screws as shown in below figures.
10. Complete the steps 1-7 from section Removing the Drain Pump.
11. Remove the four (4) mounting bolts.
12. Pull the gearcase out of the tub.
43