Technical Data; Equipment; Safety Regulations; Introduction - Kerbl 18155 Mode D'emploi

1 .3 Technical data

Type designation:
Model:
RPM :
max
Dimensions in mm (W/H/L):
Max. ambient temperature:
Max. ambient humidity:
Sound pressure level:
Subject to changes and improvements to reflect technical progress.

1 .4 Equipment

1 shearing handle
1 operating instructions

2 Safety regulations

2 .1 Introduction

This section describes the safety regulations that must always be taken into account when using the shearing system.
Reading the operating instructions is mandatory for anyone working on or with the machine.
The operating instructions must be kept in a safe place accessible at all times.
2 .2 Correct use
The intended use of the shearing machine is described in Section 1.2.

2 .3 Principles of safety

2 .3 .1 Connection to the drive

Only connect the device to undamaged, tested shear drive shafts & motors (shearing systems). Damaged shafts and motors can cause
blockages which can lead to serious injuries. Faulty electrical installations can lead to electric shock or a short circuit.
Take care to use the correct type of drive coupling, i.e. only connect a shearing handle with a "Worm-Drive"
drive shaft to a shearing system with a "Worm-Drive" coupling (Fig. 1).
Maintenance and cleaning work may only be carried out after the device has been disconnected from the drive (from the shearing system).
Never leave the machine unattended while it is connected to the shearing drive. Keep children away from the work area and keep the
device out of the reach of children.

2 .3 .2 Mandatory maintenance and inspections

Only operate the shearing machine in an undamaged and orderly condition. Defects in the shearing handle or shearing system must be
repaired by a repair and service centre.

2 .3 .3 Noise emissions / personal protective equipment

Wear hearing protection!
The noise emission at work is normally 72 – 75 dB(A). We recommend that you always wear hearing protection when working.
Wear safety glasses and gloves!
For your personal protection, we recommend that you wear safety glasses and gloves.
Personal protective equipment must be provided by the operator.

2 .4 Requirements for the operator

For the safe use of the shearing machine it is imperative that the instructions in this operating manual are observed and followed.
• The operator has read and understood the operating instructions or has been instructed in the system's operation by a specialist and
has been made aware of risks.
• The operator has experience in handling the animals to be sheared. Children and infirm persons (without supervision) are not allowed
to operate the shearing machine.
Mechanical shearing handle
18155
2800 RPM
approx. 65 x 95 x 330
0° - 40°C
10% – 90% (relative)
72 – 75 dB (A)
18