F.Bertazzoni REF36FDFZXNT Instructions D'installation Et D'utilisation page 20

ECO mode
Press the ECO MODE button to enter Eco mode; the
symbol will light up and SUPER FREEZE mode is
automatically canceled. The freezer temperature
is adjusted to -14°C/7°F and the refrigerator
temperature to 7°C/44°F. Press the ECO MODE button
again to exit Eco mode. The symbol will no longer be
lit; the freezer and refrigerator temperature will return
to the temperature set before entering ECO mode. The
change will take effect after locking.
Error codes
When there is an error, the digital temperature display
zone will display an error code in locked mode. When
multiple errors are detected, those error codes are
displayed cyclically and an alarm chime sounds. Press
any button to turn off the alarm chime (whether in
locked or unlocked mode). After the issue is resolved,
the error code will disappear from the digital display
zone.
Code Name
The humidity sensor has failed
EH
The ice maker is failing to release ice
F5
The ice maker sensor has failed
F4
The ice maker defrost sensor has failed
CC
The sensor in the ice making chamber has failed
C9
Communication between the main control board and the ice making board has failed
CA
Ice maker initialization has failed
F6
Ice maker freezing initialization has failed
E0
Refrigerator temperature sensor failure
E1
Freezer temperature sensor failure
E2
Quattro Temp Zone sensor failure
E3
Refrigerator frost sensor failure
E4
Freezer frost sensor failure
E5
Communication between the display board and the main control board has failed
E6
Ambient temperature sensor failure
E7
20
The anti-condensation heater strip
The anti-condensation heater strip can be turned on
and off using a button combination: press and hold
"ECO MODE" + "FREEZER TEMP" for 3 seconds. The
Fahrenheit symbol will flash and, after the lock button
is pressed, the anti-condensation heater strip will be
turned off.
When the anti-condensation heater strip is off, it can
be turned on again by pressing and holding "ECO
MODE" + "FREEZER TEMP" for 3 seconds, until the
Fahrenheit symbol is no longer flashing. The change
will take effect after the lock button is pressed.
The anti-condensation heater strip is for inspection
and maintenance convenience; users must not turn
off the anti-condensation heater strip, as this could
cause condensation to form.