Adjusting The Shelves; Installing The Water Filter - F.Bertazzoni REF36FDFZXNT Instructions D'installation Et D'utilisation

2.5 Adjusting the shelves

Upper end of fixed leg
Lower end of fixed leg
Slot
The shelves can be adjusted to a suitable height to
accommodate the food you wish to store.
Please adjust the shelves by following the arrows
shown in the diagram.
First raise the shelf upward,then tilt it upward to
remove it. During installation, first put the upper end
of the fixed leg into one of the upper slots on the
support bracket, then put the lower end of the fixed
leg into the third slot down from it, lower down on the
support bracket.
Cleaning the door bins
> Grasp the door bin using both hands then push it
upwards to remove. See image above.
> After washing the bin, reinstall it.

2.6 Installing the water filter

1) When the refrigerator is used for the first time,
press gently on both sides of the filter cover and pull
it downwards to open. See image above.
2) Next, rotate the dust-proof cap counter-clockwise
and remove it.
3) Remove the packaging, then slide the filter in until
it reaches the stop and rotate clockwise until it locks
securely into place.
4) When the filter symbol lights up on the display panel,
it is time to replace the water filter. The procedure for
removing the filter element is the same as that for
removing the dust-proof cap.
5) It is recommended that the filter be replaced every
six months. Make sure to shut off the connection to
the water main before changing the filter and to follow
the instructions provided above. Replacement water
filters can be ordered at www.encompassparts.com,
Part Number: Z300357.
6) If there is a centralized water filtration system in
place, it is possible to use the ice maker and water
dispenser without installing the water filter in the
refrigerator. If this is the case, do not remove the dust-
proof cap.
EN
13