Kinderkraft LEODY Guide D'utilisation page 33

appropriately - wheels down (Figure 1), move the corners apart in order to grasp middle
elements of sides, and then pull shorter sides up (sharply) to lock them (Figure 2). Grasp middle
elements of longer sides and pull them (firmly) until they lock (Figure 3). Then press down on
the center part of the bed's bottom – facing it down (Figure 4). The frame will fully unload and
the bed will be locked (Figure 5).
NOTE: Make sure that all four center elements of the bed's sides are locked! The side locking
mechanisms will not work when the bottom part of the bed will be laid flat. Therefore, when
locking the sides, the central part of the bottom must be raised. When the suspended floor (C)
is not installed, install it with the zip fastener (Figure 6A) and secure with the clamp (Figure 6B).
Place support tubes (D) into holes in the suspended floor (Figures 7A and 7B), and then place
the base (B) inside the bed (Figure 8). NOTE: For safety purposes, attach straps under the base
– starting from the opening of the entrance (open the entrance in order to fasten the straps
under the floor (Figures 9A and 9B)) and ending on the opposite side. To facilitate the
installation of the opposite side, it is recommended to partially unclip the zipper around the
suspended floor (Figure 10), and then insert the straps into holes and attach to velcro straps
under the floor (Figures 11A and 11B). Fasten the zipper around the floor and lock it by clipping
it into the buckle (Figure 12).
2. Installation of accessories*:
Skids
Lift the unfolded frame and attach skids (F) on both sides to the metal frame rack located under
the bed (Figure 13).
Changing table
Place mounting skids (H) into the changing table's frame (G) until the locking button inserts the
frame (Figures 14A and 14B). NOTE: To facilitate the installation of the skids, unfasten corners
on the changing table's velcro tabs, and after mounting the frame, close all clips. Place the
changing table by pressing it (firmly) to the bed's frame until it slides completely to sides (Figure
15A). Plastic buckles located on the cover with pockets should be placed over the bed's frame
(Figure 15B).
Panel with baskets and hooks for fixing
Insert hooks into the panel's holes (I), and then hook them onto the bed's frame (Figures 16A
and 16B).
Bed handle bar
Place the handle bar (J) in the swivel head in the direction of the arrow. Then turn it 180°
counterclockwise (Figures 17A and 17B). Then attach it to the base of the bar by positioning it
in the direction of the arrow and turning counterclockwise (Figure 18). Install mascot holders
and then hang toys on them (Figures 19A and 19B). Place the bar on one of four sides on the
frame mounting mechanism (Figure 20A). NOTE: To avoid dropping the bar on your child, make
sure that the handle bar with toys is properly mounted and stable on the frame!
3. Baby cot functions*:
Rocking function: Lift the frame up, unlock the rocking skids by pressing the locking buttons
located on both sides of the plastic cap (FIG. 21A and 21B).
33