Install The Hood - Best WC34I Manuel D'instructions

INSTALL FLUE MOUNTING
BRACKET
DUCTED AND NON-DUCTED HOODS
1. Assemble the flue mounting bracket,
adjusting outside width as shown.
Fig. 7.
2. Carefully center the mounting bracket
directly over the range hood location.
3. Secure the bracket assembly to the
ceiling using (2) 4.8 x 38 mm mount-
ing screws and dr ywall anchors.
Fig. 8. Make sure the bracket is pushed
into the corner, tight against the wall and
centered over the hood.

INSTALL THE HOOD

Note: Remove the plastic protective film
from all exterior surfaces, decorative flues
and filters, prior to final installation.
DUCTED and NON-DUCTED
INSTALLATION
1. Remove the tape on the electrical system
box and secure with (2) 3.9 x 9.5 mm
screws. Fig. 9.
2. Install hood onto the wall mounting
bracket. Make sure hood is level with floor.
Fig. 10.
3. Mark and install (4) additional drywall
anchors and screws as shown.
4. Secure hood to wall with (4) 4.8 x 38 mm
mounting screws.
3.9 x 9.5 mm
SCREWS
ELECTRICAL
SYSTEM BOX
FLUE MOUNTING BRACKET
MOUNTING SCREWS
4.8 x 38 mm
4.8 x 38 mm
SCREWS
FIG. 9
- 9 -
3.9 x 6 mm FLAT HEAD
BRACKET SCREWS
9¾"
DRYWALL ANCHORS
4.8x38mm
SCREWS
FIG. 7
FIG. 8
DRYWALL
ANCHORS
FIG. 10