Cleaning And Maintenance - Bimar DEU322 Notice D'instructions

Filter
The air inlet grille has a filter which traps dust: it is located inside and the grille must
be removed to access it.
See the paragraph below for filter maintenance.
Handle
There is a handle on the top, for transportation.
USE
Before each use, make sure that:
-the appliance is in good condition
-that the mains cable is not damaged
-that the tank is empty, and fully in place.
-that for continuous water drainage, the drain tube is properly connected to the spout
and positioned correctly whenever continuous drainage is used.
•
Connect the plug to the power socket.
•
Turn on the appliance by pressing the "
function, following the instructions above.
•
When removing the tank, the dehumidifier will stop the compressor and then the
fan will stop: the appliance is now on standby. Once it is back in place, the appliance
will automatically start in a few moments.
•
To deactivate the appliance, press the "
off completely, remove the plug from the power socket.
•
Except when ventilating the environment, keep windows and doors closed, to
maximise the effects of the dehumidifier.
During long periods of inactivity, remove the plug from the electric socket.

CLEANING AND MAINTENANCE

Warning: disconnect the plug from the power socket before routine cleaning. Keep
the appliance in an upright position during cleaning.
• Filter
It is advisable to clean the filter periodically (approximately every two weeks max or
more often if the appliance is used daily).
To remove the filter, remove the intake grille. To remove the dust build-up, use a
brush or a vacuum cleaner. Be careful not to damage any part of it. If the filter is very
dirty, wash it in warm water and rinse it a few times. The water temperature must not
exceed 40 °C. After washing, leave it to dry fully before returning it to its proper seat.
Never wash in the dishwasher.
• Tank
It is advisable to empty it after every use and wash it periodically to avoid the
formation of bacteria or unpleasant smells. To clean the tank, use lukewarm water
with a regular detergent for crockery (do not use abrasives, solvents or similar),
wash it and replace it into position.
" button and activate the desired
" button. Go to standby and to switch it