Cleaning And Maintenance - Bimar DEU315 Notice D'instructions

Handle
The top part has a handle on the side for transportation.
USE
Before each use, make sure that:
-the appliance is in good condition
-that the mains cable is not damaged
-that the tank is empty, and fully in place.
-that the water drainage spout is properly closed with the cap whenever the tank is
used, or the drainage tube is inserted properly and in place whenever continuous
drainage is used.
•
Connect the plug to the power socket.
•
Turn on the appliance by pressing the "
function, following the instructions above.
•
When removing the tank, the dehumidifier will stop the compressor and then the
fan will stop: the appliance is now on standby. Once it is back in place, the appliance
will automatically start in a few moments.
•
To deactivate the appliance, press the "
off completely, remove the plug from the power socket.
•
Except when ventilating the environment, keep windows and doors closed, to
maximise the effects of the dehumidifier.
During long periods of inactivity, remove the plug from the electric socket.

CLEANING AND MAINTENANCE

Warning: disconnect the plug from the power socket before routine cleaning. Keep
the appliance in an upright position during cleaning.
• Filter
It is advisable to clean the filter periodically (approximately
every two weeks max or more often if the appliance is used
daily).
Remove the tank, slide the filter downwards and remove it.
When cleaning the filter, only use lukewarm water. Do not use
hot water, detergents, solvents, abrasives or similar. Dry
thoroughly (do not use hot air) and then replace it correctly into
position.
• Tank
It is advisable to empty it after every use and wash it periodically to avoid the
formation of bacteria or unpleasant smells. To clean the tank, use lukewarm water
with a regular detergent for crockery (do not use abrasives, solvents or similar),
wash it and replace it into position.
• Main Unit
Wash only with a soft cloth dampened with water.
" button and activate the desired
" button. Go to standby and to switch it