: Drying. The dehumidifier operates at maximum
speed, the humidity level is automatically set
"
"
based on the ambient humidity.
This program is recommended in very humid
environments or to dry clothing (this function
optimizes the drying process).
Before hanging out the clothing, check that they
have gone through the spin cycle or wring them
by hand, so that they have lost most of the water.
For the best air flow, align the clothing and leave space between the garments.
Do not hang very wet or thick garments directly in front of the air outlet. Check
that the clearance between the clothing and the appliance is at least 30 to 50
cm (see the figure), and that there is at least 50 mm open space around the
appliance. The drying process performance depends on:
- the type of fabric (cotton, synthetic, etc.)
- the amount of humidity remaining after the spin cycle
- the quality of the garment
- the amount of drying required
Optimum drying performance may not be possible for thick or heavy garments.
Humidity
Level
Fan Button
Air Purifier
button
Select the relative humidity button (HR%). This function only
works when on "Normal" mode. Press the button to select 30 to
80 HR% (the pre-set value is 50%): each time it is pressed, it
increases by 5%. The value can be viewed on the display, which
after a few moments shows the current value (precision ± 5%).
When the equipment reaches the set degree of humidity: the
dehumidifier goes into stand-by (the compressor turns off) and
the fan motor continues to operate for desidered time. When
the ambient humidity is greater than the set humidity, the
dehumidifier turns on once again.
Press the key for about 3 seconds to display the ambient
temperature. After a few instants, the display will return to the
relative humidity.
Luminous display of relative humidity.
Colour
Blue
Green
Red
Select the fan: "Max" or "Min", when selected, the
corresponding LED turns on:
Maximum:
and Minimum:
Selects the air purifier.
The equipment operates continuously, purifying the air thanks
to the on-board filter.
Relative humidity level (HR%).
<50
(50-70)
>70