Important - Bestway 56401 Mode D'emploi

CHOOSE THE CORRECT LOCATION
IMPORTANT: The pool must be set up on a completely flat and level surface. Please do not
install the pool if the surface is inclined or sloped.
Correct conditions to set up the pool:
• The selected location has to be capable of uniformly supporting the weight for the entire time
the pool is installed, moreover the location must be flat and must be cleared of all objects and
debris including stones and twigs.
• We recommend positioning the pool away from any objects kids could use to climb into the
pool.
NOTE: Position the pool near an adequate drainage system to deal with overflow or to
discharge the pool.
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse causing serious personal injury and/or damage to
personal property and will void the warranty and prevent any service claims.
• Sand should not be used to create a level base; the ground must be dug out if necessary.
• Directly under overhead power lines or trees. Be sure the location does not contain
underground utility pipes, lines or cables of any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt surfaces. The selected
location should be firm enough to withstand the pressure of the water; mud, sand, soft / loose
soil or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and slime to develop,
therefore we recommend removing all grass from the selected pool location.
• Avoid areas prone to aggressive plant and weed species that may grow through the ground
cloth or liner.
NOTE: Check with your local city council for by-laws relating to fencing, barriers, lighting and
safety requirements and ensure you comply with all laws.
NOTE: If have a filter pump, refer to the pump's manual for instructions.
NOTE: The ladder must match the pool size and should to be used only for entering and exiting
the pool. It is forbidden to exceed the permitted payload of the ladder. Check regularly if the
ladder is properly assembled.
Assembly of the Frame pool can be completed without tools.
NOTE: It is important to assemble pool in the order shown below. Install your pools according to
the above illustrations.
ATTENTION: Do not drag the pool on the ground in order to avoid damaging the linear on sharp
objects.
1
3
4
2
5
6
7
8
5
2.59m x 1.70m x 61cm (8'6" x 67" x 24")
2.59m x 1.70m x 61cm (8'6" x 67" x 24")
S-S-005906