Chamberlain 1703EV Manuel D'utilisation page 28

1
2
14
9
15
13
1
2
15
13
Header Bracket Installation
For a canopy door, the instructions (Figures 2A & 2B)
replace Step 13 in the Owner's manual which refer to
positioning the header bracket. If you have an inward
facing lintel, which does not allow the header bracket
to be fitted directly above the garage door, you should
refer to step Garage door with inward protruding lintel.
For dual track doors, install the header bracket
50mm (2") above the high point of door travel as
shown in the Owner's manual.
Standard canopy garage doors
Canopy doors are normally provided without a frame,
for fixing to a timber frame. In this case, ensure header
bracket is located as shown below:
1
2
110 - 150 mm
3
4
3
3
5
5
5
4
3
8
12
4
3
8
FIG. 2A
7
7
Wenn das Tor eine
If the door has a lip,
hochstehende Kante
hat, von der Oberkante
measure from
des Tors aus und nicht
the top of the door,
von der stehenden
not the top of the lip.
Kante aus messen.
6
7
11
Canopy Door with Structural Obstruction and
4 rail sections
6
7
11
Garage Door with Dual Tracks – (vertical and
horizontal)
12
For pre-hung canopy garage doors
For doors either pre-hung in a metal frame or supplied
with a metal frame for self-assembly, ensure header
bracket is located as shown below:
1
2
3
4
6
1. Header bracket
2. Header frame
3. Top of Garage Door
4. Door jamb
5
10
5
10
FIG. 2B
5. Garage Door
6. Pre-hung door with frame
7. Lip
41 mm