Medisana AD 635 Mode D'emploi page 13

Functions
The aroma diffuser is a modern fragrance diffuser which uses ultrasound technology to generate a
finemistandthusdistributethefragrancethroughoutthewholeroom.Thearomadiffuserhasthe
following additional function:
■ LED: LEDs are integrated into the aroma diffuser which either light up in the selected colour or
change colour automatically.
Device and controls
Markingformaximumfillingquantity(100ml)[fig.C]
1
Operatingbutton[fig.F/G]
2
The aroma diffuser is controlled using the operating button
F). With this button you can switch the aroma diffuser on and off and you can control the LED lighting.
Thereforepressonehandontothetopofthedevice(figureG).
Thefollowingsettingareavailable:Deviceon→automaticcolourchange→singlecolour(current
colouriskept)→LEDoff→deviceoff.Youcanonlyswitchonthedevicewhenthewatertankisfilled
sufficiently(max.fillingquantity100ml
Filling the water tank with water and aroma essence
Fill the water tank with max. 100 ml fresh drinking water and add some drops of the aroma essence
(depending on the desired intensity) to the water.
ATTENTION! Make sure that the device is operated on a surface which is resistant to water, and
that it cannot tip over. In particular, when operated with mineralised water, condensation / residues
may be produced. Make sure that the mist being issued is not directed towards electronic appliances,
furniture or walls.
Cleaning and servicing
■ Before cleaning, pull the mains plug.
■ Empty the device after each use and dry the water tank with a cloth.
■ Wash the water tank with clear water when you wish to change the aroma. This prevents mixing
different aromas.
■ Only clean the outside of the device with a soft, slightly damp cloth. Then rub it dry with a soft, dry
cloth.
■ Do not under any circumstances us brushes, sharp cleaning implements, benzene, thinners or
alcohol.
Descaling
Descalethedeviceafterfiveorsixusesorevery14days,dependingonwhatisarrivingfirst.Todo
so, proceed as follows:
1. Disconnect the device from the power supply.
2. Fill the water tank with a maximum of 100 ml of water and add three tablespoonfuls of citric acid.
3. Allowtheliquidtotakeeffectforatleastfifteenminutes.
4. Empty out the liquid.
5. Wipe out the water tank with a dry cloth.
Art. 60085
For use
3
2
).
1
Adaptor[fig.F]
onthebottomsideofthedevice(figure
GB
13