Roof Modification; Side Panel Modification; Rear Panel Modification - hawa RainKit Instructions De Montage

4.5 Roof Modification

Observe the enclosed instructions for the rain gutter3R

4.6 Side Panel Modification

1. Remove side panels if already mounted at the cabinet
1.1. Loosen all screws of the side panel
Insert: TX30
Before loosening the penultimate screw, support the side panel
Tip: Loosen the screws at half height at least.
1.2. Place the side panel on the prepared horizontal storage surface
with the outside facing down.
3. Side Panel Mounting
Position the side panel at the body, align it and bolt it to the frame.
Hold the side panel in position until it is secured with at least 2 screws.
Tip: Tighten the screws at half height first.
Insert: TX30
Torque: 2 Nm

4.7 Rear Panel Modification

1. Remove rear panel
Release all screws of the rear panel
Insert TX30
Before loosening the penultimate screw, support the rear panel
Tip: Loosen the screws at half height at least.
3. Rear Panel Holder Mounting
Fix the rear panel holder with the plastic washer
and serrated locking screw at the frame.
Insert: Hexagon socket 4mm, SW10
Torque: 10Nm
left/right
18
2. Adhere gasket
2.1. Clean the upper edge of the side panel
2.2. Cut the gasket to length, peel off the adhesive film and stick it
under the upper edge of the side panel.
Adhesive film serves as a fixing aid.
2. Remove rear panel holder
Removed the screw from outside (see illustr. at right side),
holding the serrated locking nut from inside.
Insert: Hexagon socket 4mm, SW10
4. Rear Panel Mounting
4.1. Position the rear panel at the bottom with the two
brackets on the frame
4.2. Place it to the cabinet and tighten the screws
Caution: Hold the rear panel in position until it is secured with
at least 2 screws.
Tip: Tighten the screws at half height first.
up/down
Insert: TX30 Torque: 4Nm