Publicité
M.-Nr. 10412321
There is a sliding switch on the weighing electronics AD103C board. This must point to position "1". The weighing
electronics cannot be signed into the washing machine's electronics if the switch is at position "0".
A
Connect the connection cable from the weighing cells to the appropriate socket (2) on the weighing electronic
board. See Fig. 3.
A
Connect the wiring harness on the Washing machine's ELP to the appropriate socket (1). See Fig. 4.
A
Secure the wiring harness with cable holder (2) to the carrier on the ELP electronics. See Fig. 4.
A
Lay the wiring harness down the side wall and press into the cable holders in the bar in the side wall. See Fig. 5.
A
Lay the wiring harness further back behind the front spring. See Fig. 6.
A
Feed the wiring harness through the opening in the crossbar to the weighing electronics and secure with cable ties
(1) to the sub frame. See Fig. 7.
A
Secure the wiring harness with cable ties (2) to the weighing plinth. See Fig. 7.
A
Connect the wiring harness to plug (3) on the weighing electronics. See Fig. 3.
A
Fix Terostat (4) around the weighing electronics. See Fig. 3.
A
Lay foil over the weighing electronics and stick to the weighing plinth so that the weighing electronics are completely
covered.
A
Screw the earth wire to the front of the weighing plinth and to the sub-frame of the washing machine. See Fig. 8.
A
Loosen the transit safety device in the plinth. To do so unscrew the nut in the transport device (1) downwards. See
Fig. 9.
A
Remove the transport safety devices in the washing machine as described in the operating instruction manual.
A
Refit the back panel on the washing machine.
A
Refit the front panel on the washing machine.
A
Check that there is a sufficient gap between any cladding parts and the washing machine casing.
There must be no contact between the washing machine and the weighing plinth. Otherwise incorrect measurements
could be taken.
A
Fit the side panels to the weighing plinth. See Fig. 10.
A
Fit the back panel to the weighing plinth. See Fig. 11.
A
Fit the front panel to the weighing plinth. To do so fit the front panel into the side panels from above and then screw
into position. See Fig. 12.
A
Push the plate ring completely into the washing machine's drain pipe.
The plate rings serves to stabilise the drain pipe as this can distort when subjected to heat. This could result in
leakage.
A
Push the concertina hose onto the washing machine's drain pipe and secure with a hose clip.
A
Check the drainage system for leaks.
A
Calibrate the weighing system using Service mode in the washing machine. See model specific TSD.
en
cs
Montážní návod soklu s váhou WI811-30, WI814-25, WI818-25
Důvod: Sokl slouží k měření náplně pračky.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
15 von 43
21.12.2017
Publicité
