Publicité
14 von 43
No.
Mat. no.
Designation
1
Raised-head screw CEM 6 x 12
1
Weighing electronics
1
Foil
0.66
Terostat profile seal
1
Wiring harness N1-1_ST22, N1-18_ST7
4
Cable holder with expansion anchor
6
Cable ties 200 x 4.8
4
Bracket
8
Hexagonal bolts M6x25
12
Washer B 6.4
4
M6 hex nut
1
Floor fastening accessory pack
1
Concertina hose
2
Hose clip
1
Plate ring
1
Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
First read the Technical Service Documentation (TSD), then commence work.
Risk of injury due to sharp edges
CAUTION
There may be a risk of injury due to sharp edges.
Risk of injury due to sharp edges!
A
Protective gloves should be worn and the edge protection, Mat. no. 05057680, should be used.
Weighing plinth WI811-30, WI814-25, WI818-25 installation
A
Secure the plinth to the floor with the fittings supplied or with other suitable fittings. Use the spacers (1) to align the
plinth, see Fig. 1.
A
Remove the front panel from the washing machine. See model specific TSD.
A
Remove the back panel from the washing machine. See model specific TSD.
A
Unscrew the washing machine feet. They are no longer required.
A
Place the washing machine on the weighing plinth.
A
Secure the washing machine at all four corners using a bracket (1), two M6 x 25 bolts, one M6 hex nut and three B
6.4 washers at each corner. See Fig. 2.
A
Feed the connection cable from the weighing cells upwards through the opening in the plinth.
A
Secure the weighing electronics (1) to the weighing plinth with the 4.8 x 9.5 screws. See Fig. 3
21.12.2017
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10412321
Publicité
