Miele MF01 10 Notice De Montage page 36

Produktgruppe 512
36 von 38
Danger!
With the use of acidic agents, bleaches or similar chemicals, the non-return valve (DOS-R, mat. no. 05571620) must be installed in the
intake path before the detergent dispenser box, in order to prevent backflow of chemicals (e.g., when containers are changed) into the
suction pipework.
Warning!
Non-return valves must not be used with alkaline agents or with fabric conditioners or liquid starch. Check with the detergent supplier.
Cut the hose just before the connection stub.
Insert both hose ends in the non-return valve and secure them with the locking bushes.
Warning!
Take care to ensure that the direction of flow is correct (see the arrow on the non-return valve), Fig. 2, Pos. 1.
Install the dispenser pump housing DOS-G2 in its planned location (e.g., on DOS-S dispenser pump stand, Fig. 5).
Install the cable feed-throughs on the base of the dispenser pump housing DOS-G2 with their locknuts, Fig. 3, Pos. 1, Pos. 2.
Close superfluous openings with stoppers, Fig. 3, Pos. 3.
Connect the connection wires (dispenser pump and empty sensor) in accordance with the wiring diagram; see the accessory pack
with the DOS-G2 dispenser pump housing.
Install the DOS-P2 dispenser pumps in the DOS-G2 dispenser pump housing and screw them in position, Fig. 4.
Install the dispenser hoses and secure them with hose clips.
If using less than 3 DOS-P2 dispenser pumps, the vacant pump slot should be closed with the supplied cover.
Install the casing lid with 3 self-tapping screws onto the DOS-G2 dispenser pump housing.
Pass the connection wires (dispenser pump and empty sensor) through the cable feed-throughs on the connection strip to the built-in
multifunction module.
Connect the connection wires (dispenser pump and empty sensor) in accordance with the wiring diagram to the built-in multifunction
module; see the accessory pack with the DOS-G2 dispenser pump housing.
Warning!
The dispenser pump and the empty sensor connection wires (power and control current) must be laid separately in order to avoid
interference in the control circuit (electromagnetic compatibility).
Warning!
For safety reasons, the length of the connection cables must not exceed 4.5 m.
Carry out a functional check.
Warning!
Carry out a functional check only with the dispenser pump system primed and filled.
Note
Calibrate the dispenser pumps; see "Installation instructions - Modules 1 - 5, liquid dispensing".
Note
Set the dispensed quantity in accordance with the detergent manufacturer's instructions; see the washer-extractor operating
instructions.
09.08.2011 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09149680