Powersoft audio M Série Guide Rapide page 69

M50Q and M50Q HDSP+ETH
Channel Handling
Number of channels
analog input connectors
Speaker connectors
Audio
Gain
input sensitivity @ 8 Ω
Max input level
Frequency response ( ±0.5 dB , 1 W @ 8 Ω)
crosstalk (1 kHz)
S/N ratio (20 Hz - 20 kHz a-Weighted @ 8 Ω)
input impedance
THD+N (from 0.1 W to Full power)
DiM (from 0.1 W to Full power)
Slew rate (input filter bypassed @ 8 Ω)
Damping Factor @ 8 Ω, 20 Hz - 100 Hz
DSP*
architecture analog Devices SigmaDSp® 50 MipS
aD/Da converters
internal precision 28 bit data path with 56 bit internal processing
Latency
up to 4 local presets, unlimited via armonía pro
Memory/presets
Delay
parametric iir: peaking, hi/lo-shelving, all-pass,
Equalizer
crossover
Limiters
remote control
Networking*
Standards compliance 1x rJ45 auto-sensing 10/100 Mbps uTp port
Supported topologies
remote interface
12 V / 1 a max for DSp management and remote on/off
auxiliary supply
via 2 pin phoenix
* only for HDSp+ETH model.
uniquement pour le modèle HDSp+ETH.
Sólo para el modelo HDSp.
Solo per il modello HDSp+ETH.
只为HDSP模型
Nur für HDSp+ETH Modell.
только для HDSP модели.
Somente para o modelo HDSp.
4 in / 4 out mono,
bridgeable per ch. pair
4x XLr
4x NL4MD speakoN
32 dB, 30 dB, 28 dB, 26 dB,
24 dB, 22 dB, 20 dB, 18 dB,
14 dB, 4 dB, -∞, user selectable
1.94 V / +8 dBu
6 V / +17.8 dBu
20 Hz - 20 kHz
> 70 dB
> 110 dB
10 kΩ balanced
< 0.02%
(typical < 0.005%)
< 0.02%
(typical < 0.005%)
> 40 V/µs
> 5000
cirrus Logic® 24 bit 48 kHz
1.0 ms fixed latency architecture
audio Suite™ software
340 ms input delay
10 ms per channel output delay
band-pass, band-stop, hi/lo-pass
Butterworth, Linkwitz-riley, Bessel:
6 dB/oct to 48 dB/oct (iir)
peak limiter, rMS limiter,
frequency dependent rMS limiter
armonía pro audio Suite™ software
star, daisy-chain, closed loop
armonía pro audio Suite™
McV 1,5/ 2-G-3,81
2
**
DSp preset or external high-pass and voltage limiter required.
DSp preset ou passe-haut et la tension externe limiteur nécessaire
DSp preset o de paso alto y el voltaje externo limitador requieren.
DSp preset o filtro passa alto e limitatore di tensione esterni necessari.
DSP 预设或外部高通和的电压限制器所需
DSp-preset oder externe Hochpass und Spannungsbegrenzung erforderlich.
DSP пресетом или внешнего высоких частот и ограничитель напряжения требуется.
DSp preset ou passa-alta externa e limitador de tensão necessários.
Output Stage
Maximum output power per channel @ 8 Ω
Maximum output power per channel @ 4 Ω
Maximum output power @ 8 Ω Bridged
Max output power per ch. @ Hi-Z distributed line 70V**
Max output power per ch. @ Hi-Z distributed line 100V**
Maximum unclipped output voltage
Maximum output current
The power figure is calculated by driving and loading symmetrically all the
channels: uneven loads allow to achieve highest performance.
AC Mains Power
power supply
Nominal voltage (±10%)
power factor (> 500 W ouput)
consumption/current draw
idle
1/8 Max output power @ 4 Ω
1/4 Max output power @ 4 Ω
ac Mains connector
Thermal
operating temperature
cooling
Thermal dissipation
idle
1/8 Max output power @ 4 Ω
1/4 Max output power @ 4 Ω
Construction
Dimensions L x H x W 483 mm x 44.5 mm x 379 mm (19.0 in x 1.8 in x 14.9 in)
Weight
750 W
1250 W
2500 W
1000 W
1250 W
135 V
peak
65 a
peak
universal regulated switch more with pFc
100-240 V @ 50-60Hz
> 0.95
@ 115 V @ 230 V
64 W 0.6 a 64 W
605 W 11.6 a 605 W
1772 W 22.2 a 1772 W
iEc c14 inlet;
region-specific power cord provided
0° - 45° c / 32° - 113° F
Fan, continuously variable speed,
temperature controlled, front to rear airflow
218 BTu/h 55 kcal/h
955 BTu/h 241 kcal/h
1781 BTu/h 449 kcal/h
7.4 kg (16 lb)
Specifications | 67
0.51 a
5.8 a
11.1 a