Elmo Teacher's Tool TT-02s Mode D'emploi page 51

Le symbole de l'éclair à tête
deflèche dans un triangle
équilatéral,avertit l'utilisateur de
la présencede courant électrique
non-isolé deforte amplitude, à
l'intérieur del'appareil; ce qui
SA 1965
constitue unrisque de choc élec
triquepotentiellement dangereux
pour lespersonnes. Ce symbole
est placésous l'appareil.
Le symbole du point
d'exclamationdans un triangle
équilatéral prévientl'utilisateur que
le mode d'emploiaccompagnant
l'appareil comported'importantes
mesures d'utilisationet d'entretien.
SA 1966
AVERTISSEMENT :
AFIN DE RÉDUIRE LES
RISQUES D'INCENDIE ET DE
CHOC ÉLECTRIQUE,
NE PAS EXPOSER
L'APPAREIL À LA PLUIE NI
A L'HUMIDITÉ.
The connection of a non-
shielded equipment interface
cable to this equipment will
invalidate the FCC Certification
or Declaration of this device and
may cause interference levels
which exceed the limits
established by the FCC for
this equipment. It is the
responsibility of the user to
obtain and use a shielded
equipment interface cable with
this device. If this equipment
has more than one interface
connector, do not leave cables
connected to unused interfaces.
Changes or modifications not
expressly approved by the
manufacturer could void the
user's authority to operate the
equipment.
Françis
FOR UNITED STATES USERS:
INFORMATION
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant
to Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio or
television reception. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause
interference to radio and television
reception, which can be determined
by turning the equipment off and
on, the user is encouraged to try to
correct the interference by one or
more of the following measures.
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
USER-INSTALLER
CAUTION:
Your authority to operate this
FCC verified equipment could
be voided if you make changes
or modifications not expressly
approved by the party responsible
for compliance to Part 15 of the
FCC rules.
51