Cleaning Mode (Clean Up); Water Exchange In The Whirlpool; Activation When The Temperature Is Low; Cleaning Products - HOESCH NEVADA Instructions De Montage Et D'utilisation

16

Cleaning mode (CLEAN UP)

When the whirlpool is switched off manually or the water
pump or blower come to the end of its cycle, after 30
minutes a cleaning cycle is started, which lasts for 30
minutes (factory setting). The duration of the cleaning cycle
can be extended by defi ning the length in the user settings
(see MENU Operation CLEAN UP).
17

Water exchange in the whirlpool

The water in the spa should be replaced approximately
every 3-6 months. This depends among other things on the
frequency of use, proper care, water quality and many other
factors.
18

Activation when the temperature is low

During the wintertime, the pool should be emptied and
covered with cover, power supply should bedisconected.
GB
If the device is to be started after a long period of not being
used and the temperature is below zero, please proceed
with caution as the water may remain frozen in some
places. This can stop the fl ow of water and even damage
the whirlpool as a consequence of its being operated
incorrectly. To avoid situations of this kind, we advise
contacting an authorised service provider before switching
it on again.
19

Cleaning products

We recommend using whirlpool testers before bathing for
the fi rst time and during use (no less frequently than once
every two weeks). We recommend a whirlpool tester with
item number 67721. The correct pH-range for bathing is
7.0 to 7.4.
The pool can be disinfected using a granular disinfectant
(article no. 68874).
We recommend that the quantity of free chlorine in the
water is 1.0–1.5 milligrams/litre.
■ You must ensure the water is the correct pH-value
before chlorination!
■ The amount of free chlorine in the water may not be
less than 0.3 milligrams/litre!
■ We recommend that the agents are used at least 12
hours before bathing!
■ The pool should not be covered during disinfection.
20

Usage and maintenance

Usage
Generally, bathing in a whirlpool is a very restful experience
and very enjoyable. It could, however, pose a possible risk
to the health of a very small number of persons.
In case of doubts consult a doctor.
In case of the following group of people/users we advise
against using the whirlpool:
■ Babies up to 1 year old
■ People with unstable blood circulation
32
■ After consuming a big amount of alcohol
■ People with a cold or fl u
■ In case of problems with the heart/blood circulation
■ Immediately after using a sauna (allow a lengthy break
fi rst to cool down)
■ Immediately after eating
■ If children are using the whirlpool, they must be under
constant supervision by an adult.
■ When older or disabled people with limited physical
abilities use the whirlpool, special caution should
be exercised.
The water temperature in the whirlpool should not exceed
the average body temperature. The ideal temperature
range is between + 32°C and + 37°C.
For your own safety please make sure that no electric
devices or other current conducting elements can fall into
the whirlpool fi lled with water.
A whirlpool should not be used in any circumstances after or
while drinking alcohol or after lavish meals.
Note!
No soap or other foaming agents may be used before
or while bathing in the whirlpool! (Excessive foam can
damage the fi lter system).
Before using the whirlpool, you should shower thoroughly
each time, remove soap and subsequently dry your entire
body thoroughly.
Maintenance
Bath products containing solids such as moor mud, oils etc.
cannot be used.
We recommend using HOESCH foam baths for whirlpools.
After bathing, rinse the surface of the bath with water and
wipe with a damp cloth. Do not use abrasive materials! For
occasional more thorough cleaning, spray a little cleaning
agent e.g. HOESCH Cleaner (article no. 699900) on the
surface and wipe with a soft cloth. Remove stubborn dirt
with warm water and a mild liquid cleaning agent or soap
solution.
Wipe away limescale deposits with spirit vinegar and water
(avoid the fi ttings!). Follow the instructions when using drain
cleaners!
Small scratches or fragments of the shiny surface that have
lost their smoothness should be removed with the use
of e.g. the HOESCH maintenance set, item no.: 699100.
Note:
Fittings and built-in elements should only be cleaned with
a soft cloth. Damage caused as a result of improper use of
chemicals, acids and scrubbing agents will not be taken into
consideration by us as grounds for a complaint.
⚠
Note: do not use solvents, soaps or other
cleaning agents!
Cleaning the filter system (Michigan, Ontario, Winnipeg)
To ensure proper water fi ltration, the cartridge fi lter must be
serviced regularly as follows.
1. Turn off the pool (pump symbol 2)
2. Remove the cover (1) and deaerate the cartridge with
a deaeration screw (2).