Installation; Install The Monitor; Mounting; Wiring - Smartwares CMS-30100 Mode D'emploi

3 | Installation

6
3 Installation
Before doing the fixed installation, it is recommended that you consider the following:
Connect everything to familiarize yourself with the units.
Check the wireless coverage at the intended mounting locations by temporarily placing
the units.

3.1 Install the monitor

3.1.1 Mounting

The monitor is designed to stand on a table or any flat surface.
a) Pull out the stand leg on the back of the monitor.
b) Pull the two antennas on the back of the monitor to an upright position.
c) Place on any flat surface.

3.1.2 Wiring

The monitor is portable and can be used on battery power, AC power or both. When
the AC adapter is connected the battery charges until full and then operates directly
from the AC adapter.
Batteries must be purchased separately.
Battery type: 18650

3.1.3 Insert the MicroSD card (not included)

To record video, a MicroSD card is required.
a) Locate the MicroSD card slot on the right side of the monitor.
b) Insert the MicroSD card (It will only fit when in the correct position).
c) A class 10 MicroSD card with a maximum storage of 128gb is recommended.

3.2 Install the camera

3.2.1 Mounting
The camera can be mounted in any direction and on any surface that can hold its
weight. The camera must be mounted near access to mains power or an extension
may be needed.
To mount the camera, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
a) Position the camera where desired.
b) Mark the screw positions with a pen.
c) Drill the necessary holes.
CMS-30100_IM