Alarm Setup; System Manage; System Info - Smartwares CMS-30100 Mode D'emploi

6 | System operation
Illustration 30: Alarm setup chan-
nels
Illustration 31: Alarm setup channel
settings
Illustration 32: Area Edit
Illustration 33: System Info
16

6.5 Alarm setup

The monitor has an alarm function that can be set to trigger when motion is detected.
To set the alarm, do the procedure below.
a) From the main menu: Select "Alarm Setup".
b) Select "Alarm volume setup".
c) Set the desired alarm volume. (The alarm volume overrides any other sound set-
tings if triggered.)
d) Select the "Channel" (camera) that you want to use to trigger the alarm.
e) Enable the "Enable Motion Alarm" by moving the slider (it will turn green when
enabled).
f) Enable the "APP Alarm" by moving the slider (it will turn green when enabled) if
you wish to receive alarms on your mobile device. (See section "Setting up the mo-
bile app")
g) Enable the "Monitor Sound Alarm" if you wish to get an audible alarm from the
monitor.
h) Select the "Sensitivity" to set the sensitivity of the motion detector.
i) Select "Area Edit" to mask areas that you do not want to trigger the alarm. (This is
useful if you have trees or traffic etc. that is always seen by the camera.)
Note: Areas marked in orange will not trigger the motion alarm.

6.6 System manage

6.6.1 System Info

The system info provides information about the monitor. This information is mainly
used when support is required. To view the system info, do the procedure below.
a) From the main menu: Select "System Manage".
b) Select "System Info".
CMS-30100_IM