HoMedics DUO LITE Manuel D'instructions page 12

T R O U B L E S H O O T I N G
PROBLEM POSSIBLE CAUSE
• Unit will not operate • Unit is not plugged in
• Unit does not trigger • Unit is not plugged in
a pulse
• Unit is not making full contact
with skin
22
SOLUTION
• Plug in the unit by connecting
it to the power adapter and
plugging it into a household
electrical outlet.
• Check circuits, fuses, try a
different outlet.
• Plug in the unit by connecting
it to the power adapter and
plugging it into a household
electrical outlet.
• Check circuits, fuses, try a different
outlet or USB power source.
• Verify there is full contact with
the skin. The pulse button will
activate a flash pulse only when
the whole treatment window is in
contact with the skin.
F C C S T A T E M E N T
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital device complies with Canadian ICES-003.
23