Magnat TRANSFORCE REFERENCE Mode D'emploi/Certificat De Garantie page 11

THE FOLLOWING POINTS SHOULD BE HEEDED WHEN CHOOSING
COMPONENTS:
• Although core coils offer a good price-performance ratio, they also penetrate the
saturation region, which results in acoustic distortions. The coils should therefore have
as little ferrite / iron content as possible.
• Be sure to adhere to the recommended minimum cable diameter.
• With regard to condensers, electrolyte condensers with the highest possible electric
strength should be used.
• The components should not be mounted directly on the speaker. Secure the parts with
screws, cable ties and hot-setting glue. Keep the cable runs as short as possible.
• The components are available from specialist electronic equipment dealers.
CABLES TO BE USED
To transport the output from the amplifier to the subwoofer efficiently and reliably, you
should bear in mind when selecting the speaker cable that 2 x 4 mm² gauge wiring is
required for cable lengths in excess of 3 meters. 2 x 2.5 mm² cable is sufficient for shorter
runs. Lay the cable in such a way that short-circuiting cannot occur, i.e. the cable may at
no time be jammed between metal parts. Make sure that terminals on the speaker are
screwed tight and check their contact at regular intervals.
SUBWOOFER POLARITY
Because of the different spatial conditions prevailing in different vehicles, subwoofer
polarity can best be determined by trial and error. To do this, choose some music material
you know very well and select the setting you like most. Some radios / control units also
offer the possibility of setting the polarity on the appliance itself (phase). One change in
polarity corresponds to a phase shift of 180 degrees.
CONNECTING THE ILLUMINATION (FIGURE 3)
Important, please read carefully.
Connect the +12 v terminal to the +12 v electrical circuit in your car. The +12 v terminal
of the subwoofer light (fig. 3, right screw terminal) must be connected to the positive cable
on the vehicle's electrical wiring system via a cable fuse (500 mA slow-blow, precise
specification: T500mAL 250 volt, fuse and fuse holder not supplied).
Now connect the car hi-fi receiver's remote control connection to the amplifier's REM
control jack on the terminal (Fig. 3, middle terminal screw). A cable with a cross-section
of 0.75 mm² is sufficient for connecting the amplifier's REMOTE connection to the control
device.
GB
10
Autogood products Internet store "130"