Euronda EUROSEAL 2001 PLUS Manuel D'instructions page 34

3. Lower the sealing lever. The lever will pass from position -G- to position -H-.
When the sealing procedure is completed the light - I - will turn red and the signal
bell will ring.
4. Raise the sealing lever passing from position -L- to position -M-.
When the lever is raised the light will turn green again and the signal bell will stop ringing.
The machine is ready for the next sealing without having the wait for a cooling period.
If the operator doesn't return the lever to its start position immediately after the sealing
procedure is completed, the power unit will stop itself automatically (so the tape does not
burn). The bell however will continue to ring. As soon as the lever is returned to its start
position - G - the power unit will automatically switch on again. It will take several seconds
to restore the optimal sealing temperature.
12
EUROSEAL ® 2001 PLUS