Changing The Battery; Storage - NUK 10.256.380 Mode D'emploi

Caution!
• Do not use other chemical agents or
disinfectants to clean as this may
damage the device.
• Make sure that the tip of the device is
pointing downwards so that none of the
cleaning fluid enters the housing.
2. Then leave the probe head to dry
completely for at least one minute.

6.2 Changing the battery

The battery must be replaced as
soon as the following symbol
appears in the LCD display 3.
1. Take a small, thin object (e.g. a paper
clip) and press it into the unlocking
opening 6 of the battery compartment
lid 9 while, at the same time, pushing this
opening outwards with both thumbs (see
figure D).
2. Firmly holding the device, carefully lift out
the battery 8 using a small, thin object
(e.g. a paper clip) (see figure E).
3. Insert the new CR2032 battery with the
positive terminal facing upwards and the
minus terminal facing downwards by
sliding the battery underneath the metal
hook and pressing down until it clicks
into place (see figure F).
Caution! If incorrectly fitted, the battery
compartment and even the device may
become damaged.
4. Push the battery compartment lid 9 back
onto the device until it audibly clicks into
place.

6.3 Storage

To avoid contamination of the reflective
mirror 5 place the cover 1 to the
themometer after each measurement. Only
store thermometer with cover.
- 40 -