Beyerdynamic Opus 600 Notice D'utilisation page 59

Opus 600 – Technical Specifications
Max. SPL. . . . . . . . . . . . . . . . . . . . . . . . . 146 dB
AF transmission range
SDM 660 . . . . . . . . . . . . . . . . . . . . . . . . 55 - 18,000 Hz (close miking 2 cm) at 80 dB SPL
SDM 669
SEM 681
Rear attenuation. . . . . . . . . . . . . . . . . . . -20 dB at 1 kHz / 120° (SDM 660)
Signal-to-noise ratio . . . . . . . . . . . . . . . . > 110 dB
T.H.D. . . . . . . . . . . . . . . . . . . . . . . . . . . . < 0.5% at 1 kHz
Transmission range . . . . . . . . . . . . . . . . . 100 m
Power supply . . . . . . . . . . . . . . . . . . . . . 2 x 1.5 V batteries (AA)
Current consumption . . . . . . . . . . . . . . . approx. 85 mA
Operating time . . . . . . . . . . . . . . . . . . . . > 20 hours with alkaline batteries
Dimensions
Length S 600 . . . . . . . . . . . . . . . . . . . . . . . . 188 mm
Shaftø S 600. . . . . . . . . . . . . . . . . . . . . . 38 mm
Weight with batteries . . . . . . . . . . . . . . . 163 g
TS 600 beltpack transmitter
Frequency range . . . . . . . . . . . . . . . . . . . 506 - 530 MHz
Modulation. . . . . . . . . . . . . . . . . . . . . . . FM
Nominal deviation. . . . . . . . . . . . . . . . . . ± 40 kHz
Radiated transmitter power . . . . . . . . . . 20 mW
Compander system. . . . . . . . . . . . . . . . . NE572
Signal-to-noise ratio . . . . . . . . . . . . . . . . > 110 dB
T.H.D. . . . . . . . . . . . . . . . . . . . . . . . . . . . < 0.5% at 1 kHz
Frequency response . . . . . . . . . . . . . . . . 50 Hz - 18,000 Hz
Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 mV - 0.3 V adjustable, at nominal deviation
Power supply . . . . . . . . . . . . . . . . . . . . . 2 x 1.5 V batteries (AA)
Current consumption . . . . . . . . . . . . . . . approx. 85 mA
Operating time . . . . . . . . . . . . . . . . . . . . > 20 hours with alkaline batteries
Dimensions (L x W x D) . . . . . . . . . . . . . . 110 x 63 x 21.5 mm
Weight with batteries . . . . . . . . . . . . . . . 145 g
4-pin connection . . . . . . . . . . . . . . . . . . Pin 1 = Ground, Pin 2 = IN1, Pin 3 = IN2,
*NOT for use in the USA **NOT for use in the USA or Canada
65 - 16,000 Hz (close miking 2 cm) at 80 dB SPL
50 - 18,000 Hz (close miking 2 cm) at 80 dB SPL
-15 dB at 1 kHz / 145° (SDM 669)
-15 dB at 1 kHz / 180° (SEM 681)
668 - 692 MHz
774 - 798 MHz*
790 - 814 MHz**
841 - 865 MHz**
Pin 4 = +5 V; refer also to chapter 4.5 AF connection
59