Machine Setup - Uline H-8925 Mode D'emploi

NOTE: To minimize damage during shipping,
tower is unhooked from the frame and is laying
down. To stand the tower up, two people and
9/16" wrench will be needed.
1. Remove the 5 nuts and washers located on the
tower end of the frame using a 9/16" wrench.
(See Figure 2) The extra hole is to be used to lag the
machine to the floor.
2. Two people may now stand the tower up. Position
the tower so the film carriage faces the turntable.
Align the holes in the base of the tower with the 5
threaded studs in the frame. (See Figure 3)
3. Tighten the 5 bolts using the 9/16" wrench.
FILM LOADING
1. Place the film on the film mandrel.
2. Follow the film feed diagram and thread the 1.8m
(6ft.) film tail all the way through the rollers.
(See Figure 4)
3. Attach the film securely to the pallet. Tying the end
of the film in a knot often helps secure the film to the
pallet.
OPERATING
Simply step on the foot pedal to start the turntable drive
motor. The foot pedal is a maintained switch. Pressing
the pedal again turns the turntable motor off. Apply film
as desired by raising and lowering the carriage.
PAGE 3 OF 18

MACHINE SETUP

4. Unwrap the machine and refer to the operations
5. Place forks of the forklift through the tubes provided
If the OPTIONAL ramp (H-1071) is purchased:
OPERATION
FILM FORCE
Film force is controlled by the knob on top of the large
black mandrel. Turning the knob clockwise increases
the Force-to-Load. This in turn increases the post-stretch
of the film.
TURNTABLE SPEED ADJUSTMENT
The turntable speed is adjusted by a built-in
potentiometer dial on the AC frequency drive.
Turn clockwise to increase, counter-clockwise to
decrease. The maximum turntable speed is 12 RPM.
Figure 2
Figure 3
manual to use it.
at the rear base of the module, remove the
machine from these skids, and place it at the
designated wrap area.
Select a ramp position. The ramp can be positioned
anywhere in a 180° rotation around the front of
the turntable. There should be a 1/4" gap between
the turntable and the ramp. The ramp should be
fully supported by the floor. Both the ramp and the
machine should be lagged to the floor.
Figure 4
0321 IH-8925