System Description; System Setup - Uline H-8925 Mode D'emploi

Figure 1
MACHINE PLACEMENT
Place the automatic stretch wrap machine close to
an area where you will be wrapping your pallet loads.
Make sure that there is sufficient room to load/unload
the machine and that you do not stretch the wiring
cable. Remember, you will need to provide electrical
service to a 120 VAC, 15 AMP outlet.
PAGE 2 OF 18

SYSTEM DESCRIPTION

Film Carriage
Turntable

SYSTEM SETUP

Tower
FLOOR WEIGHT BEARING TOLERANCE
The floor must be able to bear the weight of the
machine, the weight of the maximum load, plus a
safety factor. The floor must also be able to tolerate
the stress of the machine's operation. If the fork trucks
will operate on the same weight bearing area, add
the weight of the trucks to the weight bearing stress
tolerance requirements.
Electrical
Enclosure
0321 IH-8925