Uline H-4025 Mode D'emploi page 4

REPLACING A DAMAGED BLADE
1. Verify that power is off, the machine is unplugged
and all components are cool.
2. Use a 3mm Allen wrench to remove the screws from
the back plate.
3. On the front of the machine, use a 4mm Allen
wrench to loosen the screw below the blade.
(See Figure 7)
Figure 7
4. Apply pressure to the air nozzle assembly to
counteract pressure from the sensor wheel.
(See Figure 8)
Figure 8
PAGE 4 OF 15
MAINTENANCE CONTINUED
Blade
4mm
Allen
Wrench
Blade
5. From the back of machine, use a 3mm Allen wrench
to remove the screw that runs through the blade.
(See Figure 9)
Figure 9
6. With a needle nose pliers, remove the dull blade.
(See Figure 10)
Figure 10
Blade
7. To install new blade, reverse steps 1 through 6.
3mm
Allen
Wrench
0221 IH-4025