Local Air Conditioner Use; Starting Your Local Air Conditioner - Hisense APC12 3010F Instructions D'installation

Operating your local air conditioner properly helps you to
obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ The air conditioner display shows the current room
temperature.
■ When changing modes while the air conditioner is
operation, the compressor will stop for 3 to 5 minutes before
restarting.
NOTE:The symbols may be different from these models, but the functions are similar.
1. Select the mode. See " MODE ".
2. Select the fan speed. See " FAN ".
3. Set the temperature. See "TEMPERATURE".
4. Press POWER button to start the air conditioner.
NOTE:
When the air conditioner is turned on, it will run according to the
previous setting.
Only if the unit is operated in UNLIKELY VERY HUMID air, water
will be collected in the container inside the unit. If the
water container is full, the air conditioner will stop. The
screen will displays "E5" to inform you to empty the internal
container.
Operating modes:
1. Press and release MODE until you see the symbol flashes for the
desired setting.
2. Choose Cooling, Dry, Fan Only or Heating.
Cooling-Cools the room. Press FAN to select High,
Mid or Low. Press the Plus or Minus button to adjust the
temperature.

LOCAL AIR CONDITIONER USE

Starting Your Local Air Conditioner

■ If a button is pressed during this time, the compressor will
not restart fo another 3 to 5 minutes.
■ In Cooling or Dry mode, the compressor and condenser fan
will stop when the room temperature reaches the set
temperature.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Dry-Dries the room. The air conditioner automatically selects
the temperature. The fan runs on Low speed only.
NOTE:Dry mode should not be used to cool the room.
Fan Only-Only the fan runs. Press FAN to select High,
Mid or Low.
Heating-heats the room. Press FAN to select high,
Mid or Low. Press the PLUS or MINUS button to adjust the
temperature.
NOTE:
Heating is NOT available for cooling only air conditioner.
Fan Speed
1. Press and release FAN to choose the desired fan speed.
2. Choose High, Mid or Low.
Auto-automatically controls the fan speed depending on the
current room temperature and temperature control setting.
High-for maximum fan speed
Mid-for normal fan speed
Low-for minimum fan speed
17