Hisense APC12 3010F Instructions D'installation page 21

■ Dry-Dries the room. The air conditioner automatically
selects the temperature. The fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room.
A decrease or rise of up to
remote controller if you still feel uncomfortable.
Fan Only-Only the fan runs. Press FAN button to adjust
■
fan speed.
NOTE: Auto fan speed cannot be selected in Fan Only mode.
Heating-Heats the room. Press FAN to select the fan speed.
■
Press the up or down TEMP button to adjust the temperature.
SMART Mode
Press the SMART button, Smart mode (fuzzy logic operation) is
directly regardless of the unit is on or off. In this mode,
temperature and fan speed are automatically set based on the
actual room temperature.
To cancel Smart Mode, just press the MODE button.
SMART
Operation mode and temperature are determined by indoor temperature.
With Heater models
21°C
21-23°C
23-26°C
26°C
Cooling only models
23°C or below
23-26°C
26°C
NOTE: Temperature, airflow and direction are controlled
automatically in smart mode. However, a decrease or rise of
up to 2°C can be set with the remote controller if you still feel
uncomfortable.
Button
FAN
SWING
2°C can be set with the
22°C
Room temperature
decrease 2 °C
operate for 3 minutes
26°C
Room temperature
decrease 2 °C
operate for 3 minutes
26°C
Adjustment
Indoor fan speed alternates among
High, Medium and Low each time
this button is pressed.
SUPER
SUPER button is used to start or stop fast cooling or heating.
1. Press SUPER button. The air conditioner automatically
sets the fan speed to High and the temperature to 16°C.
Fast heating operates at auto fan speed,changing the set
temperature automatically to 30°C.
2. To turn off Super control, press any button on the remote
control or control panel except Timer On, Timer Off, Clock,
Dimmer,Ifeel and Swing.
NOTE:
■ In the SUPER mode you can set airflow direction or timer.
■ SMART mode are not available in SUPER mode.
■ SUPER button is ineffective in SMART mode.
Fan Speed
1. Press FAN button, Choose desired fan speed.
after
Auto-Automatically controls fan speed depending on
■
current room temperature and temperature control
setting.
NOTE: Auto fan speed cannot be selected in Fan Only
mode.
after
High for maximum fan speed
■
Mid for normal fan speed
■
Low for minimum fan speed
■
20
SUPER
fast heating
fast cooling
ON ON
OFF
OFF