Rear Panel - Alto Professional TX15 Guide D'utilisation

Features

Rear Panel

5
7
6
4
1
1. AC Input: Use the included power cable
to connect this input to a power outlet.
9
Make sure the Power Switch is set to off
3
when connecting or disconnecting the
10 cable.
11 2. Power Switch: Use this switch to power
the loudspeaker on or off. Make sure the
8
Volume knob is set to its minimum
(counterclockwise)
turning it on.
3. Power LED: This LED lights up when the
loudspeaker is on.
4. Cooling Vent: Keep the area in front of
this vent clear from obstructions. The fan
behind the vent cools the amplifier,
preventing overheating.
5. Volume: Turn this knob to adjust the
loudspeaker's volume.
6. Input: Use a standard XLR cable (not
included) to connect your audio source to
this input. Make sure to set the Input
Selector to the correct position.
7. Input Selector: Set this switch to the
Line position when using a line-level
audio source connected to the Input. Set
this switch to the Mic position when
using a microphone connected to the
Input.
8. Mix Out: Use a standard XLR cable (not
2
included) to connect this output to the
input
another TX loudspeaker).
9. Signal Limit LED: This LED lights up
when the audio signal being sent to the
loudspeaker is "clipping" or distorting. If
this LED illuminates frequently or steadily,
reduce the volume of your audio source.
10. Contour: Engage (depress) this button to
emphasize low and high frequencies by
+3 dB. Disengage (raise) the switch for a
flatter response for live performance or
for maximum output.
11. Ground Switch: Engage (depress) this
switch to reduce hum or noise.
6
position
of another loudspeaker
before
(i.e.,