Antari DarkFX Spot 670 Mode D'emploi page 6

power input, all fixtures in the chain will draw power via the first fixture. Total current draw of
all fixture must not exceed 8 amps maximum.
Data Linking
Serial data links is required when operating the fixture through DMX controller. When
planning the data link please consider following:
Maximum recommended length of data link is 500 meters.
․
Maximum recommended number of data linked fixtures is 32 units.
․
Fixture must be daisy chanined by linking data output to next data input.
․
Data output must be terminated on last fixture of each chian using a termination plug.
․
Avoid long parallel run of AC power and data cables as it may cause interference on
․
the data link.
DMX Connector Pin Assignment
The fixture provides 5 pin XLR connector for DMX connection. Diagram below indicate pin
assignment information
DMX Connection
When using standard DMX controller, connect the DMX output of the controller directly with
the DMX input of the first fixture in the DMX chain. Connect the DMX output of the first
Pin
1
2
3
Function
Ground
Data-
Data+
6