Storage; Damage Prevention - Powerwerx POWERPLAY HOTROD 2500 Mode D'emploi

Damage Prevention

If your pressure washer is subjected to freezing temperatures, damage could occur.
This type of damage is not covered under warranty. To avoid possible damage, a small amount of
antifreeze can be used. Place the unit on its side with the water inlet facing upwards. Pour 1/4 cup
of antifreeze into the water inlet. Disconnect spark plug wire. Pull recoil starter several times to
circulate the antifreeze in the pump system.
Reconnect spark plug wire. It is also important to make sure the wand and all hoses are
disconnected and drained of all water or they may burst. When taking the pressure washer out of
storage, run water through the system until it runs clear.
Long-term Storage
If you plan on storing your pressure washer for an extended period of time, the following steps
should be followed.
• Add fuel stabilizer to the fuel tank to minimize the formation of fuel gum deposits during

storage.

• Run the engine at least 5 minutes after adding stabilizer to allow it to enter the entire fuel
system.
• Drain the engine oil from the engine as described in "Engine Oil Replacement" in the Owner's
Manual and immediately replace it to prevent a no oil start-up when the machine is used next.
• Pour approximately one teaspoon of engine oil through the spark plug hole and pull the recoil
starter slowly until you feel increased pressure, which indicates that the piston is on its
compression stroke and leave it in this position. This closes both the intake and exhaust valves
to prevent the inside of the cylinder from rusting.
• Cover the pressure washer and store it in a clean, well-ventilated and dry place.
NOTE: If a fuel stabilizer is not used, all gasoline must be drained from the tank
and carburetor to prevent gum deposits from forming on these parts and causing possible
malfunction of the engine.
07mf2_POWERPLAY MANUAL_EN_11614.indd 14
STORAGE
13/06/12 2:53 PM