Detergent Injector - Powerwerx POWERPLAY HOTROD 2500 Mode D'emploi

Using water only can complete some cleaning jobs, but for most job requirements,
a detergent is recommended in order to penetrate and remove the dirt more effectively. When using
a pressure washer approved detergent, make sure the surface is dry.
Wetting the surface first is not recommended. It will dilute the detergent and will reduce the
cleaning effectiveness.
Avoid hot surfaces or direct sunlight. This will minimize the chances of the detergent damaging the
painted surface.
DO NOT let the detergent dry out or it may damage the painted surface. Allow the
detergent to remain on the surface for a short time before rinsing with clean water under
high pressure.
• This pressure washer is intended for use with qualified branded pressure detergents only.
• Do not use powdered soaps, which can clog the injection system.
• Follow the detergent manufacturer's directions.
• The siphon tubes come pre-assembled in the soap tank cap from POWERWERX™.
• Soap tanks will hold your liquid soap and work automatically with the soap tip.
• When using a detergent, the wand must be fitted with the black tip detergent nozzle.
• If the throttle lever is not in the fast position, the injection of the detergent may be decreased
or stopped completely. In this case move, the throttle lever to full or wide open, to increase
engine speed and pressure.
Important Note: When you have finished using the detergent injector system, remove the
injector filter from the detergent container or shut off the valve on the soap tank and insert a higher
pressure tip. Let the pressure washer run until you no longer notice detergent coming out of the
wand. This will prevent detergent from gumming up the wand and reducing pressure for next use.
Important Notice: When you have finished using the detergent injector system, it is
recommended to flush out the remaining detergent by letting the pressure washer run until you
no longer notice detergent coming out of the wand. Remove the injector filter from the detergent
container and insert a higher pressure tip. This will prevent detergent from gumming up the wand
and reducing pressure for next use.
07mf2_POWERPLAY MANUAL_EN_11614.indd 12

DETERGENT INJECTOR

13/06/12 2:53 PM