Infrared Remote Control; Manual Operation - Goobay 90655 Mode D'emploi

5.3.2 Infrared Remote control

• For outputs A and B there are separated selection buttons available for source devices
1-4.
• Use the selection buttons A1-4 to activate signal transmitting of the respective source
device on output A. The LED (Active A) on the front side appears.
By pressing this button again, the device will change to stand-by mode.
• Use the selection buttons B1-4 to activate signal transmitting of the source device on
output B. The LED (Active B) on the front side appears.
By pressing this button again, the device will change to stand-by mode.
• Use the MUTE button to mute the output devices by the Ultra HDMI Matrix 4 x 2 Matrix.
5.3.3 Manually operating
• For outputs A and B there are separated selection buttons available for source devices
1-4.
• The Select/Power button is a multifunctional button.
• Press the Select/Power button for around 2 seconds to switch the Ultra HDMI Matrix 2 x
4 into standby-mode. Press this button again for around 2 seconds to switch the device
on.
• Switch the ON/OFF switch to "O" for switching it off and to "I" for switching it on.
• Press the Select/Power button for one short time to switch between the source devices.
A green LED shines to identify the channel.
This process is a cyclic function.
• Use the RESET button on the front side of the device to set the Ultra HDMI Matrix 4 x 2
back to initial state.
Output A
Output B
Muting
Switching
on and off
Selecting the
source device
Resetting
13