Fm Radio; Tuning To Radio Stations; Storing Preset Radio Stations; Autostore: Automatic Programming - Philips WACS7000 Manuel D'utilisation

8. FM radio

8.1 Tuning to radio stations

1
Connect the supplied FM wire antenna to the
Center and Station (see 3.Installation)
2
Check that the set is switched on or in standby
mode (see 5.Basic functions)
3
Press SOURCE once or more times to select
Radio
➜
Playback screen appears. Display shows:
Radio, the radio station frequency and a
preset number (if already programmed)
4
Press and hold 3 or 4 until the frequency in the
display starts running.
➜
The radio automatically tunes to a station of
sufficient reception. Display shows Searching
during automatic tuning
➜
If a station is received in stereo,
➜
When you are receiving an RDS station,
is shown
5
Repeat Step 3 if necessary until you find the
desired radio station
●
To tune to a weak station, press 3 or 4 briefly
and repeatedly until optimal reception is
detected.
44
is shown
SAME ARTIST
DBB

8.2 Storing preset radio stations

You can store up to 60 preset radio stations in
the memory.

8.2.1 Autostore: automatic programming

Autostore automatically starts programming
radio stations from Preset 1. Available stations
are programmed in the order of radio
frequencies: RDS stations followed by FM
stations. A maximum of 10 RDS stations will be
stored (from Preset 01 to Preset 10).
1
To select Autostore radio,
a. Press MENU
b. Use the navigation controls 3 or 4 and 2 to
select Autostore radio
➜
Display shows: Autostore Please wait...
➜
After all the stations are stored, the first
autostored preset station will then play
automatically.

8.2.2 Manual programming

1
Tune to your desired radio station (see 8.1
Tuning to radio stations).
2
Press PROGRAM on the remote control.
➜
The display shows:
PORTABLE
SAME ARTIST SAME ARTIST
DBB
SEARCH
SMART EQ