Aqua Medic T Controller HC Mode D'emploi page 5

1. Product Description
The AB Aqua Medic Temperature Controller HC is generally delivered with a sea-water resistant
temperature sensor. The unit is ready for connection. The heating device can be connected to the
main plug.
2. Heaters
Heaters of any type (i. e. glass or metal aquarium heaters, low voltage heating cables with
transformer, warm water supply by a magnetic valve) can be controlled with this Temperature
Controller. The maximum output amounts to approx. 1.000 Watt.
3. Description of the front panel
1. Display
2. Light „User On"
3. Measurement adjustment switch
4. Set-knob for adjustment
5. Temperature sensor
6. Power plug
4. Installation
1. Connect to 220 V power source.
2. Set switch (2) to „T" (display of temperature).
3. Place the temperature sensor into the aquarium and fix it with an AB Aqua Medic electrode
holder. After a few minutes, the actual temperature of the aquarium water is indicated.
5. Adjusting the nominal values
A. Put switch (2) to „Set" (to adjust the desired value).
B. To change the value, use the „Set" knob (1).
C. Set switch (2) back to „T".
The unit is now ready for use. As soon as the temperature value falls below the adjusted value, the
unit activates the power plug (4) and switches the user (heater) on.
5