Before Using Your Appliance; Preparing Your Dishwasher For First Use; Setting The Water Softener - Summit DW242WADA Manuel D'utilisation

BEFORE USING YOUR APPLAINCE
Preparing Your Dishwasher for the First Use
•
Make sure the electricity and supply water specifications match the values indicated in the
installation instructions for the machine.
•
Open the door of the dishwasher.
•
Remove all packaging material inside the machine.
•
Set the water softener level. (See chapter of setting the water, model depending).
•
Set the rinse aid dosage (See chapter of filling the rinse-aid and setting).
•
Fill the salt container (see chapter of filling the dishwasher salt dispenser, model depending).
•
Fill the rinse aid compartment. (See chapter of filling the rinse aid and setting).
•
Place the dishes in accordance with the instructions in the user manual.
•
Put adequate amount of detergent into the detergent dispenser. (See chapter of filling the
detergent).
•
Make sure that the upper and lower impellers rotate freely.
•
Select program according to amount of dirt (See chapter of Program table).
•
Close the door of the dishwasher. (Push the baskets in. Then lift the door upwards and push
until it clicks into position).
CAUTION: To prevent injuries, ensure that your hand is not jammed or crushed between the
door and appliance
WARNING: While the appliance is run ning, if you open the door, all functions are automatically
interrupted
CAUTION: There may be escape of hot steam when you open the door of your machine. Be
careful of getting injured.
Setting the Water Softener (Model Depending)
•
The dishwasher needs soft water for good cleaning results. Hard water results in a build-up of
calcium deposits on dishware and in the dishwasher. Your dishwasher has a special water
softening system to remove the hardness of the tap water. Setting this system correctly will
increase the washing effectiveness.
•
Water supplies with a hardness level higher than 9 °f (French Water Hardness) needs to be
softened.
•
If the hardness level of the water that you use is above 9 °f (French standard for water hardness)
or if you are using well water, than it is recommended to use a filter and water purification
devices.
•
The dishwasher is programmed at the factory setting level 1 (inactive) of water hardness. If this
setting corresponds to the hardness of your water, you do not need to do anything more.
•
The dishwasher must be programmed for the water hardness in your area.
•
To find out the hardness level of water in your area, contact your local Water Board or Determine
water hardness level by the help of test strip provided.
WARNING: If you move to a different location, the level of water hardness will possibly be
different. It is essential to setting again the water hardness in order to obtain optimum washing
efficiency.
9