Summit DW242WADA Manuel D'utilisation page 10

Test Strip (For Models With Water Softener)
The washing effectiveness of your machine depends on the softness of the tap water. For this
reason, your machine is equipped with a system that reduces the hardness in the main water supply.
The washing effectiveness will increase when the system is correctly set. To find out the water
hardness level of water in your area, contact your local water board or determine water hardness
level by using the test strip (if available). Follow the steps in the image when use the test strip.
WARNING: If the water is well water or has a hardness level above 9 °f, we recommend that you
use filter and refinement devices.
Water Hardness Table
Level German °dH
1 0-5
2 6-11
3 12-17
4 18-22
5 23-31
6 35-50
Adjust the water hardness setting of your machine according to the level specified on the test
strip (if available).
NOTE: Hardness level is adjusted to level 1 as a factory setting.
NOTE: If you only ever use combination products in your dishwasher, you can change the
softener level.
Salt Indicator
Please check the salt indicator on the control panel to see whether there is adequate amount of
softening salt in the dishwasher or not. You need to refill the salt reservoir with salt whenever the
salt warning indicator appears on the control panel of your machine. In order to add salt to the
machine.
1. Open the door of the machine,
Press and hold "Start/Pause + On/Off" keys for 3 seconds.
2.
3. The machine gives an audible warning when it is ON.
Press and hold "Program Selection + Cancel" keys until "SL" is represented on the display,
4.
display, the machine will display the last setting,
The amount of Salt is adjusted by pressing "Program Selection + Cancel" keys.
5.
6. After the adjustment, turn off (by pressing Start/Pause + On/Off keys) the
machine to save the selected salt amount.
French °f British °E
0-9 0-6
10-20 7-14
21-30 15-21
31-40 22-28
41-55 29-39
56-90 40-63
10
Indicator
L1 is shown on the display.
L2 is shown on the display.
L3 is shown on the display.
L4 is shown on the display.
L5 is shown on the display.
L6 is shown on the display.