FAULT
Whitish stains remains
on dishes.
Dishes do not dry.
Rust stains form on
the dishes.
Detergent remains in
the detergent
compartment.
If your appliance shows other symptoms than those described above, or if you have checked all
items listed as the cause and the problem still exists, then call Summit Appliance Customer Service
1-800-932-4267
at
.
POSSIBLE CAUSE
Not enough detergent used.
Rinse aid dosage and/or water
softener setting set too low.
High water hardness level.
Salt compartment cap not closed
properly.
Drying option is not selected.
Rinse aid dosage set too low.
Stainless-steel quality of the
dishes is insufficient.
High level of salt in wash water.
Salt compartment cap not closed
properly.
Too much salt spilled in the
Dishwasher while filling it with salt.
A poor mains grounding.
Detergent was added when the
detergent compartment was wet.
TROUBLESHOOTING
Use the correct amount of detergent, as
instructed in the programme table.
Increase rinse aid and/or water softener
level.
Increase water softerner level and add
salt.
Check that the salt compartment cap is
closed properly.
Select a programme with a drying option.
Increase rinse aid dosage setting.
Use only dishwasher-proof sets.
Adjust the water hardness level using
water hardness table.
Check that the salt compartment cap is
closed properly.
Use funnel while filling salt to the
compartment to avoid spillage.
Consult a qualified electrician
immediately.
Make sure detergent compartment is dry
before use.
30