Installation Information - DURAVIT D-Code 70095 Serie Notice De Montage

Important information
About the mounting instructions
These mounting instructions comes as part of the Duravit
whirltub and should be read carefully prior to
installation.
Explanation of the key words and symbols
DANGEr! At high risk of fatal hazards or
serious injuries
ADVICE! For avoiding property damage
Link to the Electrical Installation section
Link to installation information in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and tightness
Indication of the temperature
Control unit
(Number depends on the whirl system)
6
WH_M_D-Code_Panel_Magnets/16.04.2
Target group and qualification
The whirltub must only be installed by trained plumbing
engineers. The electrical installation may only be carried
out by qualified electricians.
NoTE!
Local installation regulations and any country-specific
standards must be observed at all times.
Safety information
DANGEr! risk of fatal electric shock.
> Do NOT remove any whirltub components.

Installation information

Please read pre-installation datasheets prior to the
installation. These are available to download on the
Internet at www.duravit.com.
Checking the whirl system (Diagram 20)
20
> Switch on the whirl system for 10 minutes:
Run this through once completely in the case of
circuits with different levels of intensity.
> Leave the water in the bathtub and wait 10
minutes.
> Check to make sure that it is leak-tight.
> If adjustments are required, repeat the check.