Starting Therapy - Transcend EZEX Guide Rapide

STARTING AND ENDING THERAPY

Starting Therapy

1. The Transcend control panel
consists of a Power button
(bottom), Ramp button (top),
and two LED lights. (Refer
to image)
2. Ensure that the device is
connected to a power
source and is in Standby
mode. (See Powering Your
Transcend)
3. Put on your mask and make sure that proper fit is achieved.
4. Press the lower, gray Power button (
flow will begin as the blower delivers your prescribed therapy pressure.
Using the Ramp Function
Ramp settings will be programmed by your healthcare provider as appropriate.
1. Initiate ramp by pressing the Ramp (top) button after the Power button has been pressed.
Note: The Ramp button on the Transcend will not work unless your healthcare provider has
preset the ramp function.
2. Pressure from the device will be lowered to a preset starting pressure and will gradually increase
over a preset time interval until the device reaches your prescribed starting therapy pressure.
3. To accelerate the ramp time, hold down the Ramp button. The device will quickly increase
pressure until reaching your prescribed therapy pressure.
Ending Therapy
To end therapy, press the Power button to return the device to Standby mode.
Green LED
) to turn on Transcend and enter Therapy mode. Air
TRANSCEND EZEX QUICK GUIDE
Power Button
• ENGLISH • PAGE 8
Ramp
Button
Yellow LED