Checklist - Motak PKU0155SA Manuel D'installation Et D'utilisation

Checklist

If a problem arises during operation of your ice machine, follow the checklist below before
calling service. Routine adjustments and maintenance procedures are not covered by the
warranty.
Problem
Ice machine does not
operate.
Ice machine stops and can
be restarted by turning the
ice machine OFF and then
ON.
Ice sheet is thick
Ice machine does not
release ice or is slow to
harvest.
Part Number: 000016426 Rev 00 08/2020
Section 4
Before Calling For Service
Possible Cause
No electrical power to the ice
machine.
Ice machine needs to be
turned on.
Curtain/damper in open
position (down).
Safety limit feature stopping
the ice machine.
Water trough level is too
high.
Power was turned off/on
during freeze cycle and ice
remained on evaporator.
Curtain/damper was opened
then closed in the harvest
cycle before the ice released.
Ice machine is dirty.
Ice machine is not level.
Low air temperature around
ice machine.
To Correct
Replace the fuse/reset the
breaker/turn on the main
switch/plug power cord into
receptacle.
Place the toggle switch in the
ICE or ON position to start ice
making.
Curtain/damper must be
in the closed position and
capable of swinging freely.
Refer to "Safety Limit
Feature".
Adjust the float.
Allow ice to thaw and release
from evaporator, then
restart.
Allow ice to thaw and release
from evaporator, then
restart.
Descale and sanitize the ice
machine.
Level the ice machine.
Air temperature must be at
least 40°F (4°C).
43