GCE proFIT 60010 Mode D'emploi page 15

noTE: in case when two torches are to be used too close to eachother, the required distance can be
adjusted this way that the first torch holder is directed to the front and the second one to the back of the
machine.
5.
MaInTEnanCE
5.1. daily
•
Continuously check the tightness of the nozzle-torch seat
•
Wipe gCE proFIT
•
check if there are damages in the hoses and electric cable. Exchange damaged parts.
•
Lubricate the spindle of rotating wheel with shell "vitrea 31" or its equivalent.
5.2. monthly
•
Make sure that vertical and horizontal torch movement is going well and all hand wheels are functional.
•
clean torch rack, distance adjustment bar and all parts of the torch holder.
•
check tightness the gas hoses and gas manifold incl. adjustment valves. tighten leaking connections and
replace the damaged parts.
5.3. quarterly
•
dismount the clutch lever and screws and separate the upper part of the machine body from the lower part.
(make sure that motor cables are not stretched).
•
clean the interior parts of the machine carefully without damaging the speed control unit.
Fig.12: Bevel cutting and strip cutting with two torches
®
with a cloth to clean it from slag and metal oxides.
15/222
GB