GCE proFIT 60010 Mode D'emploi page 13

4.5. striPs cutting with guiding rail
4.5.1. place the rail on the part to be cut. if there is a need for a length more than 2m then connect the second
rail with the first as shown on Figure 7.
4.5.2. place gCE proFIT
rear wheel should fit,wthat it doesn't move.
4.5.3. adjust the cutting speed in relation to particular nozzle and material thickness. adjust also movement
direction. turn clutch lever to the direction of arrow to stand-by position.
4.5.4. set the cutting torch on the metal sheet at the place of cut start. ignite and set pre-
flame as required according to instruction above. preheat the material on the ignition temperature.
4.5.5. Fully open cutting oxygen valve in the same time and start moving machine by
movement control knob in requested direction as shown on the Figure 3 or 4.
4.5.6. after the cutting is over, stop the machine by bringing the movement control switch in central position,
shut all the gases of. gas valves shall be closed in following sequence: 1. cutting oxygen, 2. fuel gas,
3. heating oxygen.
4.6. striPs cutting with beam
(profile) guidance (see Figure 8)
4.6.1. use a metal profile which is 15 mm high at
least and fix it on the metal sheet according to
Figure 8.
4.6.2.Smooth edges of the metal beam should be
300 mm away from the edge to be cut.
4.6.3. Castor wheel should be slightly leant to the
template so that it moves to lean on the beam
when the machine moves backward.
4.6.4. continue according to points 4.5.3. – 4.5.6.
4.7. CIRCLE anD RaDIUS CUTTInG
4.7.1. Install the components of circle pole and
centre piece as shown in Figure 9 for circular and
Fig.9: Circle cutting
small diameters are to be cut, then cutting torch
should be installed on the side of circle pole.
4.7.2. Make a punch sign on the center of the
circle to be cut which is 1.5 mm deep and 60
degree angle. disengage the revolving wheel and
®
place gCE proFIT
4.7.3. It is recommended to drill 3 mm hole at the
place of cut start-end to ensure smooth cut
connection. it is possible to pierce also material
directly by oxygen which is usually recommended
for metal sheets with thickness below 80mm.
4.7.4. place the machine at the cut start point to
have cutting nozzle in exact position against the
drilled hole. start cutting according to points 4.5.3.
– 4.5.6.
®
on the rail. Make sure that front and rear wheels fit in the rail furrows.
radius cutting. if circles with
on the metal sheet.
13/222
switching of
Fig.8: Cutting with beam guidance
GB
heating