Master Section - Samson MIXPAD MXP124 Manuel Du Propriétaire

Top Panel Controls

Master Section

This following section details the master section of the mixer.
21. TAPE IN (RCA jacks) - Stereo line
level input, on RCA connectors,
for connecting the output of
devices such as MP3, CD,
computer sound-card, or any
other line level device.
22. TAPE OUT (RCA jacks) - The signal present at this connector is the MAIN
bus signal before it has passed through the MASTER level control and
graphic equalizer. The nominal output level is -10dBV and the impedance
is 100 Ohms.
23. MIX 2 - These line level MIX 2 outputs can be used to drive a second
speaker system or connect to a stereo device such as computer sound
card, MP3, or recorder. The signal at the MIX 2 jacks follows the MIX 2
level control knob allowing you to set a different level at the outputs.
24. MAIN MIX - The MAIN MIX ¼" jacks can be connected to a power
amplifier, powered speaker system, or inputs of a digital recorder. The
signal at the MAIN OUT jacks follows the MAIN volume fader.
25. FX SEND (MXP124FX) - The signal present at the FX
SEND output is sent from the FX bus, which is fed from
the FX send on the input channels.
MON SEND (MXP124) - The signal present at the MON
SEND output is sent from the MON bus, which is fed
from the MON send on the input channels.
26. PHONES Output - Connect standard ¼" TRS stereo headphones, 60 to 600
Ohms. The PHONES output level is controlled by the MIX 2/PHONES
control.
27. POWER Indicator - The POWER LED lights up to
indicate that the main POWER switch (located on the
rear panel) is on.
28. Output Level Meter - The output level meter allows you
to monitor the level of the signal, which is being sent
to the MAIN MIX jacks.
NOTE: To avoid distortion, adjust the MAIN MIX level
control so that the 0 indicator LED lights occasionally.
MXP124/MXP124FX
21 22
21 22
21 22
23
25
26
23 24
23 24
27
25
28
25
26
26
29
30
27
27
28
28
29
29
30
30
24
31
3
3
34
31
31
32
15
32