Rear Panel - Pioneer A-40AE Manuel D'instructions

Rear Panel

  
 
1. SIGNAL GND terminal: The ground wire of the turntable
is connected.
2. CONTROL IN/OUT jacks: By connecting Pioneer brand
audio devices, centralized control is possible, for example
you can control other audio devices with this unit's remote
controller. (p12)
3. DIGITAL IN OPTICAL/COAXIAL jacks: Input digital audio
signals from a playback device with a digital optical cable
or digital coaxial cable. (p11)
4. SPEAKERS terminals: Connect speakers with speaker
cables. (Not compatible with connection using banana
plugs or Y plugs.) (p8, 9, 10)
5. AC IN: Connect the supplied power cord. (p13)
6. PHONO MM jack: Analog audio input jacks for connecting
a turntable. (p12)
7. LINE IN jacks: Input audio signals from a playback device
with an analog audio cable. (p11)
8. LINE OUT jacks: Connect a recording device, such as a
cassette tape deck. Connect to the LINE IN jacks on the
recording device using analog audio cable. To select the
input source for recording, use the INPUT SELECTOR
dial on this unit or use the remote controller.
9. P.AMP DIRECT jacks: When using this unit as a power
amplifier, connect the pre-amplifier here. (p13)
0 P.AMP is an abbreviation of POWER AMP.
6

 
Before use
