Sunred TA15 Instructions D'emploi page 4

38. The wheels are only for the purpose of moving the heater. Once the heater is in the desired position, the wheels
should be removed for safety purposes.
39. Do not use this heater with a programmer, timer, separate remote-control system or any other device that
switches the heater on automatically, since a fire risk exist if the heater is covered or positioned incorrectly.
40. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
41. Children should be supervised to ensure that they do not play with the appliance.
Operation
Connect the power cable to a 13 amp supply that is located in a safe, dry area.
•
The switch on the heater head is used to control the heat settings. (I) for 2100W – (0) for OFF.
•
Although the patio heater is weather proof, do not use when raining or in wet conditions.
•
Always disconnect the power cable from the electrical supply when the patio heater is not in use.
Care and maintenance
•
When disconnected from the electrical supply, clean the surface of the patio heater with a damp cloth. Never
use corrosive or solvent cleaners or immerse in water.
•
Any maintenance or repairs including replacing the halogen tube should only be carried out by a qualified
electrician or by a recommended service center.
Technical specification
•
Power supply 220V-240V ~ 50Hz
•
Wattage max 2100W
•
Net weight 5.5 kg
•
Insulation class I
•
Height 78 cm
Assembly
Step 1: Connect the Tube to the Base by screwing them together.
Step 2: Feed the Power Cord through the Base and the Tube, and pull through around 1.9 meters of cable.
www.sunred.nl