Tanks Screen; Alarms Screen - Dometic Interact Manuel D'utilisation

Dometic Interact
• Generator Exerciser: Use the toggle button to
enable or disable the generator exerciser.
When you enable this setting, the Ventilation Alert
pop-up message appears. The alert message does not
appear when the generator activates based on the set
schedule. The generator runs as scheduled if the
ignition is turned off. If the ignition is turned on during
a particular day that the generator is scheduled to run,
it would skip running the generator that day unless the
ignition is turned off.
The following generator exerciser settings are
available:
– Days: Tap the desired days to specify the days on
which the generator exerciser should run.
– Run Time: This tumbler controls the duration for the
generator exerciser. Use the tumbler to set your
desired time setting (10–2400 minutes).
– Start Time: These tumblers control the time at
which the generator exerciser should start. Use the
available tumblers (hour and minute) to set your
desired time settings.

4.1.7 Tanks Screen

The Tanks screen allows you to monitor and control the
holding tanks, such as the fresh, gray, and black water
tanks.
14 Tanks Screen
EN
From this screen, you can monitor and control the
following functions:
• Indicator Bars: The horizontal bars indicate the fluid
levels for the various tanks (percent full), which are
monitored continuously by the sensors attached to the
outside of the tanks. These indicators are for
monitoring purposes only and do not have any control
functions.
• Water Pump: Use this toggle button to turn the water
pump on or off. The water pump is deactivated by
default.

4.1.8 Alarms Screen

The Alarms screen allows you to configure alarms for the
system, including alert tones, alarm times, and alarm
names.
15 Alarms Screen
The Alarms screen is the main screen from which
configured alarms can be monitored, enabled, or
disabled. You can complete the following actions from
this screen:
• Use the toggle button next to an alarm to enable or
disable the alarm.
• Tap the alarm name to open the Alarm Edit window
and edit a configured alarm.
• Tap the add button to open the Pop-Up Time window
and create a new alarm.
When an active alarm triggers, a pop-up window appears
on all displays in the coach along with the sound selected
for the alarm.
Operation
13